Description
Power over Ethernet HAT for Raspberry Pi 3 Model B+, 802.3af power-sourcing equipment required
Key Features
- 802.3af PoE
- Fully isolated switched-mode power supply
- 37x57V DC, Class 2 device
- 5V/2.5A DC output
- 25mm x 25mm brushless fan for processor cooling
- Fan control
How to:
Hardware Required
- Raspberry Pi PoE HAT
- A Raspberry Pi 3 Model B+
- An Ethernet cable
- Power-sourcing equipment for a 802.3af Power over Ethernet network
Connecting your PoE HAT to the Raspberry Pi
- Before installing the PoE HAT, you must attach the supplied spacers in the four corners of the board
- Then connect the Raspberry Pi PoE HAT to the two 0.1" headers (40 + 4) that are fitted on the Raspberry Pi
- Once the PoE HAT board is connected, you can power the Raspberry Pi through its RJ45 network connector
- The fan will turn on and off automatically depending on the temperature of the main processor on the Raspberry Pi.
Disconnecting your PoE HAT
Pull evenly so that it detaches from all the pins at the same rate; do not pull one end of the connector off before the other
Dimension