Description
The CC Debugger is primarily used for debugging and programming the flash on CCxxxx 8051-based System-on-Chip (SoC) devices from Texas Instruments. CC Debugger also supports CCxxxx RF transceivers. In addition, CC Debugger is used for configuring the CC85xx devices with PurePath Wireless Configurator.
Key Features
- Performance
- Compatible with the original TI CC Debugger
- Supported Operating Systems: Windows 2000, Windows xp sp2/sp3, Windows Vista 32bit, Windows 7 32bit
- Target voltage: 1.2V~6V
- Capable of powering the target board from the debugger
- Operating temperature: 0℃~85℃
- Supported Software
- IAR Embedded Workbench For C8051
- SmartRF Flash Programmer
- SmartRF Studio
- SmartRF Packet Sniffer
- PurePath Wireless Configurator
- Connects to PC
- Computer connection via USB interface
- Connects to target board
Target board connection via 10-pin IDC connector (2x5 2.54mm pitch). The figure below shows the header pinout:
LED Status
- OFF:The debugger has no power or there is no valid firmware on the debugger.
- AMBER (BOTH LEDS ON):The debugger is powered, but there is no valid firmware.
- RED LED BLINKING:The Debugger is in Boot Recovery Mode.
- RED LED ON:No device detected. This might be due to old firmware on the CC Debugger, or a problem with the hardware connection (make sure the target board is properly powered and connected correctly).
- GREEN LED ON:The target device has been properly detected. It is possible to start programming/debugging.
Downloads
Development resources:user manual, schematic, firmware, software, etc.
Wiki: www.waveshare.com/wiki/CC_Debugger
Package Content
- CC Debugger × 1
- USB cable × 1
- 10-pin flat cable × 1