STLINK-V3MODS - STLINK v3 Mini In-circuit STM32 Debugger Programmer 15x30mm

The STLINK-V3MODS is a small size debugging and programming probe for STM32 microcontrollers.

The JTAG/SWD interfaces are used to communicate with any STM32 microcontroller located on an application board. The STLINK-V3MODS also provides a Virtual COM port interface enabling the host PC to communicate with the target microcontroller through one UART, and bridge interfaces (SPI, I2C, CAN, GPIOs) simplifying for instance the field programming through bootloader. The STLINK-V3MODS is ready to be embedded in a master application and can be directly soldered on the PCB motherboard.

• Modular probe with small size: approximately 15 x 30 mm
• Direct-to-PCB implementation by 2 x 16-pin 1.27 mm edge castellated vias, with all signals available in required minimum PCB surface
• Self-powered through a USB connector (Micro-B)
• USB 2.0 high-speed compatible interface
• Direct firmware update support (DFU)
• JTAG / serial wire debugging (SWD) specific features:
  • 3 V to 3.6 V application voltage support and 5 V tolerant inputs
  • JTAG communication support
  • SWD and serial wire viewer (SWV) communication support
• Virtual COM port (VCP) specific features:
  • 3 V to 3.6 V application voltage support on the UART interface and 5 V tolerant inputs
  • VCP frequency up to 15 MHz
• Multi-path bridge USB to SPI/UART/I2C/CAN/GPIOs specific features:
  • 3 V to 3.6 V application voltage support and 5 V tolerant inputs
• Drag-and-drop Flash programming
• Two color LEDs: communication, power

• datasheet
• User Manual