null

DEV-16885 - SparkFun MicroMod All The Pins (ATP) Carrier Board GPIO Interface

SparkFun

No reviews yet Write a Review
SKU:
057-DEV-16885
MPN:
DEV-16885
  • 100% Original Products
  • GST Invoice
  • Earn 3% Cashback
₹1,528.10 inc. GST
₹1,295.00 ex. GST
17 people looking at this.

Technical Specifications

Brand:
SparkFun

Warranty Information

All the products supplied by Evelta are genuine and original. We offer 14 days replacement warranty in case of manufacturing defects. For more details, please visit our cancellation and returns page.

Description

The SparkFun MicroMod ATP Carrier Board is a MicroMod Processor Board with Access All The Pins (i.e. ATP). The MicroMod ATP Carrier Board includes a location for a MicroMod Processor Board. The board has a built-in backup battery for Processor Boards with an RTC. The USB Type C connector is used to power, program the processor board, or pass serial data to a serial terminal. The board can be powered from the VIN pin with a recommended voltage between 3.3V to 6.0V. It can also be powered with 5V from the USB C connector. This board breaks out the MicroMod Processor Board's pins on the M.2 connector to 0.1" spaced female headers and PTH pads on the edge of the board.
The reset button will reset the processor. The boot button will put the processor into a special boot mode. Depending on the processor board, this boot pin may not be connected. There are two locations on the board for Qwiic-enabled device. The board is 3.30"x2.20". There are 4x mounting holes on each corner of the board. There are 2x additional mounting holes by the SparkFun logo for Qwiic-enabled devices.

Key Features
  • M.2 Connector
  • Operating Voltage Range
    • ~3.3V to 6.0V (via VIN to AP7361C 3.3V Voltage Regulator)
    • 3.3V (via 3V3)
  • Ports
    • 1x USB type C
    • 1x USB type A Host
    • 2x Qwiic Enabled I2C
    • 1x CAN
    • 1x I2S
    • 2x SPI
    • 2x UARTs
    • 2x Dedicated Analog Pins
    • 2x Dedicated PWM Pins
    • 2x Dedicated Digital Pins
    • 12x General Purpose Input Output Pins
    • 1x SWD 2x5 header
  • 1mAh battery backup for RTC
  • Buttons
    • Reset
    • Boot
  • LEDs
    • Power
    • 3.3V
  • Phillips #0 M2.5x3mm screw included
Resources

SparkFun MicroMod Ecosystem Video