Adafruit QT Py ESP32-S2 2.4GHz WiFi Development Board with uFL Connector

This QT Py incorporates ESP32-S2 Espressif WiFi microcontroller is a highly-integrated, low-power, 2.4 GHz Wi-Fi System-on-Chip (SoC) solution that now has built-in native USB. The QT Py ESP32-S2 has a single-core 240 MHz chip without bluetooth support.

Note: This board does not come with an onboard antenna, you need a uFL connector antenna. The antenna is not included in the package.

• 3.3V regulator with 600mA peak output
• Reset switchfor starting your project code over, boot 0 button for entering bootloader mode
• USB Type C connector
• ESP32-S2 240MHz Tensilica processor- the next generation of ESP32, now with native USB so it can act like a keyboard/mouse, MIDI device, disk drive, etc!
• 4 MB Flash & 2 MB PSRAM
• Native USB supported by every OS - can be used in Arduino or CircuitPython as USB serial console, MIDI, Keyboard/Mouse HID, even a little disk drive for storing Python scripts.
• Can be used with Arduino IDE or CircuitPython
• Built-in RGB NeoPixel LED with power control to reduce quiescent power in deep sleep
• Battery input pads on underside with diode protection for external battery packs up to 6V input
• 13 GPIO pins

STEMMA QT / Qwiic 4-pin 1mm Pitch White Female Connector Cable 150mm Long - Both Side can be purchased seperately.